Innokin Riptide Crios Instructions < Go Back

Innokin Riptide Crios Kit - Instructions available


Buy today with our lowest price guarantee*

  • 1x 3000mAh RipTide battery
  • 1x Crios tank with 0.25 ohm pre-installed coil
  • 1x Extra 0.25 ohm coil
  • USB charging cable
  • Available in Blue, Green, Yellow & Purple



If you’d like some guidance for vaping with the Innokin RipTide Crios kit, please read the following instructions. If you have any questions at all, please do not hesitate to contact us.

Charging the Innokin RipTide Crios Kit

Your RipTide will indicate when the battery needs charging. If all 3 of the small LED lights are on the battery life is 31-100%, if there are only 2 lights it is between 11-30% and if 1 light is on you will need to recharge your kit. We recommend that you do not let you battery run empty and to charge your RipTide when 1 LED is showing.

Plug the micro USB end into your kit and the USB end into a USB charging port to begin charging.

Do not leave your battery unattended when charging and make sure you do not over charge.

Filling the Crios Tank

To fill your RipTide Crios tank, you will need to unscrew the cap of the tank and make sure that you are not over filling. The e liquid will need to be put in the side of the tank and not through the center chimney. When the tank is filled, screw the cap back on and leave for 5 minutes before vaping.

Changing the Crios Coils

If the taste of your e liquid is slightly burnt, it is time to change your coils.

First of all, you will need to unscrew the tank from the battery. Then unscrew the bottom of the tank, which should remove the coil. Once you’ve removed the coil, replace it with a new one and you can begin vaping. 

Make sure you leave your vape kit standing for a few minutes to prime the coil (allow the e liquid to saturate the cotton).